![]() Ensure a bucket or tray is under to catch any water or sewage that may spill out. If the pipes are corroded and difficult to remove, use a pipe cutter to cut the pipe near the pump. Begin by loosening the nuts that secure the pipes to the pump, then gently pull the pipes out of the pump. It is essential to wear protective gloves when handling pipes as they may be sharp or corroded, causing injury to your hands. You will need to remove the pipes that connect to the sewage ejector pump, which may require using a wrench or pliers. Once the power is off, it is time to disconnect the plumbing. Tagging or marking the breaker is essential so other individuals do not accidentally switch it back on.īefore proceeding, make sure to check that the power is off by using a voltage meter. If you opt to shut off the circuit breaker, locate the circuit breaker panel and turn off the pump’s circuit breaker. If you choose to unplug the pump, locate the plug and gently pull it out of the socket. You can unplug the ejector pump or shut off the circuit breaker that supplies power to the pump. There are two methods of turning off the power supply. Here are the steps you should follow: Step 01: Turn Off the Power Supply ![]() Steps on How to Fix a Sewage Ejector Pumpįixing a sewage ejector pump can be challenging, and it is important to proceed carefully to avoid further damage or injury.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |